In Repetier-Server 0.80 we have implemented some really nice new features, but we want more – much more. We have so many ideas, but to realize them, we need your help. Since our version was for almost 2 years in beta (and therefore free) and now runs stable and reliable, we have decided that Repetier-Server 0.80 will be no longer beta.

It's a nearly complete rewrite (80%) of the well known firmware. While rewriting it to simplify it for future improvements and to improve the speed, I added tons of remarks and documentation, helping everyone, who wants to change it a bit.

The firmware runs on the following boards: • RADDS • • Gen 6 • Gen 7 with 16MHz and 20 MHz • Sanguino • • • PiBot for Repetier Features: • RAMP acceleration support. • LCD Menu directly connected or via I2C (since version 0.60) • Supports click-encoder, key matrix and push buttons. • Path planning for higher print speeds.

(since version 0.32, 2011/9/24) • Fast ooze prevention system. (since version 0.35, 2011/10/8) • Trajectory smoothing for smoother lines. (since version 0.32, 2011/9/24) • Nozzle pressure control for improved print quality with RAMPS. (since version 0.32, 2011/9/24) • Fast - 16000 Hz and more stepper frequency is possible with a 16 MHz AVR. (since version 0.32, 2011/9/24) • Multiple extruder supported (experimental). • Standard ASCII and improved binary (Repetier protocol) communication.

• Autodetect the command protocol, so it will work with any host software. • Continuous monitoring of one temperature. • Important parameters are stored in EEPROM and can easily modified without recompilation of the firmware. • Stepper control is handled in an interrupt routine, leaving time for filling caches for next move.

• PID control for extruder temperature. • Interrupt based sending buffer (Arduino library normally waits for the recipient to receive written data) • Small RAM memory print, resulting in large caches. • Supports SD-cards.

Hp 990c driver windows 7 download. But you can skip this step if there is no instruction to do so. Follow all of the steps until the process is finished. • You have to connect the cable to your PC and HP Deskjet 990c printer.

• mm and inches can be used for G0/G1 • Works with Skeinforge 41, all unknown commands are ignored. • Dry run: Execute your G-Code without using the extruder. Bondan prakoso kecil.

This way you can test for non-extruder related failures without actually printing. • User defined and generic thermistor table( just set r0,t0,beta,r1,r2) in config (since version 0.31). • Software PWM for boards, where the PWM timer is used for other purposes. Download from Use with many existing host software packages or try the software.