File Name: Size: 2450 KB Uploaded: - This page is updated daily and on this page you will get information about books, ebooks, pdf and more, if you are looking for a book or an ebook You can see on this page what you are looking for. If you do not get what you are looking for here.

Hopefully you see the other pages and you can contact us on the email listed Instructors are encouraged to visit this site regularly; they can also register on this site to be notified of important changes via email. (read: privacy policy).

You will find information for the following issues here: • • • • • • • • • • What happens if I can no longer switch on the printer? • Check main switch (right-hand side). Should be in 'up' position. • Circuit breaker activated. Press button on the main connection block. • 9-volt battery flat. Do not replace when power is off.

EXCEL 2000 Series Service Manual 9-3 Introduction This chapter contains all part numbers necessary to order EXCEL 2000 and the EXCEL 2000 Opaque printer replacement parts and assemblies. For part numbers relating to the EXCEL 2000 Auto Flush Assembly, please refer to the Auto Flush Addendum.

Measure voltage at battery or call the hotline. What should I do if I can no longer see anything on the display? • If the printer is running normally but no display is visible, adjust the contrast. Please call the hotline. 'No air for warmup Fault' • Check input pressure on pressure gauge (approx. • Check quality of compressed air. It must be free of oil and water.

What should I do when 'Ink Out Fault' occurs? • Check the fluid level (make-up, ink). • If the level is OK, please call the hotline. What should I do when 'Phasing Fault' occurs?

• Is the head dirty? Turn the printer off, clean with make-up solution, dry the printhead and re-start. • Check ink expiry date and replace with fresh ink if expired. What should I do when 'No Signal Fault' occurs? • Is there a jet? If not, the nozzle is blocked.

• The catcher may be overflowing and the return suction line blocked. It should be cleaned. What should I do when 'Reservoir Overfill' occurs? Download instrumental song bailando by enrique. • Cleaned too often or for too long, too much fluid in the module. • Drain some fluid (approx.

20ml) from the module. Call the hotline. What should I do when 'HV Fault' occurs? • High Voltage plates in the printhead are dirty. • Short circuit through ink.

Clean head thoroughly. What should I do when 'Empty Time Too Short Fault' occurs? • Check ink pressure (left-hand pressure gauge). If necessary, call the hotline. • Check ink expiry date. Ink viscosity may be too low.

• Replace with fresh ink. What should I do when 'Flow Time Too Long Fault' occurs? • Check ink system for leaks. • Replenish ink.